Reliance Foundry carries a select line of bollards that can be set into new concrete by positioning the bollard in its intended location and then pouring the concrete. The bollard becomes a fixed device, creating an architectural perimeter.
It is important to note that with this installation method, the bollard's function is strictly visual and offers limited impact resistance. It is intended for bollards that operate as visual traffic guides for restricting vehicle access.
What you will need
Steel Bollard, Embedded Mount
To protect the finish, keep bollards in original packaging until the exact moment of installation.
Handle with care to avoid scratching or damaging bollard surfaces as abrasions will lead to rust.
Once scratched, bollards cannot be repaired to original form without re-finishing the entire surface.
Study the site plans
Site plans are generally created by the architect of the project.
Refer to site plans to locate the precise center point of each bollard.
Ensure that the plan coincides with the site and familiarize yourself with the intended arrangement of the bollards.
Check for hazards
Always check for hazards such as water pipes, gas lines, and underground wiring before digging.
Prepare the site for concrete
Please consult your local Building Code Department to determine the frost line in your area.
Dig below the frost line; the new concrete footing must reach beyond this frost line.
Note: If the frost line is less than 12" below surface level, dig to a minimum depth of 12". This is recommended in order to create stability.
The diameter of the hole should extend to a minimum of 10".
Center the auger on the installation mark and bore a hole to the required depth and diameter.
Ensure the area is properly formed to create a perimeter that will hold wet concrete.
Use a dirt tamper to compact the soil below the intended surface.
Prepare the bollard for designated location
Keep the bollard in its protective packaging.
Carefully place the bollard base near the installation position.
Pour the concrete
Mix the concrete
Ensure that the proper ratio of water and concrete mix is used.
The concrete should have a similar texture to moldable clay.
Place the bollard in designated location
When ready to install, remove the protective packaging.
Do a visual inspection of the bollard and ensure that the plastic plug (A) is intact.
Insert the steel rebar (B) into the bottom holes of the bollard. This will anchor the bollard in the concrete.
Measure 36" from the top of the bollard and mark with masking tape. This indicates the height above surface grade.
Lower the bollard into the designated location until it reaches the masking tape.
Pour the concrete
Take care to pour the concrete evenly, ensuring the surface is level.
Hold a level against the side of the bollard and ensure that it remains plumb.
Note: Once the concrete has cured, there will be no way to make any adjustments.
Allow the concrete to cure
A minimum of 2–3 days should be given for concrete to cure before beginning construction projects on new concrete surfaces.
Note: Moisture in the environment and cool temperatures can significantly slow the process.
Reliance Foundry manufactures its products to the highest design standards to ensure their durability. Reliance’s bollards are finished with long-lasting powder-coating. In most North American environments, routine inspections and cleaning will ensure that bollards retain their aesthetic appeal. Proper care and maintenance are required to maintain the finish and ensure a full service life.
Unit 207, 6450-148th Street
Surrey, British Columbia,