X
  • No products in the quote
X
  • No products in the quote

Installing Decorative Plastic Bollard Covers

Home > Bollards > Bollard and Post Cover Installation > Installing Decorative Plastic Bollard Covers

Protect your pipe bollards while enhancing their aesthetic appearance. Decorative plastic bollard covers help to increase visibility and reduce maintenance of pre-installed pipe bollards. Bollard covers are made of high-quality polyethylene for the best corrosion resistance, and their secure mounting system reduces the likelihood of theft. Plastic bollard covers can be installed using a spray foam to fix bollard covers onto the pipe bollard.

It is important to note that Reliance Foundry’s bollard covers are primarily decorative. Adding bollard covers to existing pipe bollards will not affect impact resistance. The level of impact resistance is directly related to the original installation.

PARTS LIST

#

PART

QTY

1

Plastic Bollard Cover

1

INSTALLATION EQUIPMENT

Measuring Tape

Hand Saw

Spray Foam(1) (adhesive)

NOTE

Diagram showing the parts list

Before installation

Inspect the pipe bollard
Examine the pre-installed pipe bollard for signs of damage. Any rust should be removed, and abrasions should be covered as soon as possible. If the damage is beyond repair, a new pipe bollard may need to be installed.

Hold a level vertically against the side of the pipe bollard and ensure that it is plumb.

Note: Any damage or tilting of the pipe bollard can affect the performance of the bollard cover.

Diagram showing a level vertically against the side of the pre-existing pipe bollard to ensure it is plumb

Secure the bollard cover

Slide the bollard cover over the pipe bollard
Slide the bollard cover over the pipe bollard and hold it at 5–6″ above surface grade.

Apply the spray foam
With the bollard cover held up at 5–6″ above surface grade, insert the spray foam nozzle upward into the space between the pipe bollard and bollard cover. Carefully dispense the spray foam evenly around the surface.

Note: The bollard cover must be held up over the pipe bollard as the spray foam is applied—to prevent accidents and injuries, have a second person to help with this step or ensure that the proper resources are available to set into place.

Diagram showing the bollard cover help up at 5 to 6 inches while spray foam is applied

Set the bollard cover
Lower the bollard cover all the way down and ensure that it is centered over the pipe bollard.

Immediately remove any excess foam with a putty knife.

Press a level vertically against the bollard cover and ensure that it is plumb.

Note: A minimum of 10 minutes at 70ËšF is required for the spray foam to set. Do not disturb until it has fully cured.

Diagram showing a level against the bollard cover to ensure it is plumb

Clean the bollard cover

Clean the surface of the bollard cover
Use a cloth to clean off any dust or debris.

Inspect

Inspect the installation
From a distance, examine the plane of view.

Ensure the bollard is plumb.

Check the bollard for any signs of surface damage
Abrasions should be covered as soon as possible to prevent rust and ensure the proper life of the bollard. For damage repair or other servicing needs, please contact Reliance Foundry’s sales department.

Care and maintenance

Reliance Foundry manufactures its products to the highest design standards to ensure their durability. Reliance Foundry’s bollards are finished with long-lasting powder coating. In most North American environments, routine inspections and cleaning will ensure that bollards retain their aesthetic appeal. Proper care and maintenance are required to maintain the finish and ensure a full service life.

1. Please refer to the adhesive manufacturer’s MSDS before using

Diagram showing a decorative plastic bollard cover fixed onto a pipe bollard using spray foam
Sign in

No account yet?

Popular requests:
Start typing to see products you are looking for.